Filter
Top Products
OPERATION
25
8058-223
Cutting height selection
Before Starting
1. Read the sections on Safety and Controls before
starting the machine.
2. Perform the daily maintenance before starting
(see Maintenance Schedule in the Maintenance
section).
3. Check that there is sufficient fuel in the fuel tank.
4. Adjust the seat to the desired position.
5. Set the deck cutting height by inserting the lift pin
into the desired cut height.
The following conditions must be fulfilled before the
engine can be started:
• The blade switch must be pressed downward into
the disengaged position.
• The parking brake must be up into the activated
position.
• Both steering controls must be in the locked
(outer) neutral position.
8011-441
Lengthways adjustment