Filter
Top Products
ASSEMBLY
iNSTALL SEAT (See Figs. 3 and 4)
* Remove bolt and flat washer securing seat tocardboard
packing and set aside for assembly of seat to tractor.
Remove the cardboard packing and discard.
* Connect switch to seat.
Place seat on seat pan so all three (3) bottom pads
are positioned over large slotted holes in pan.
TO INSTALL HOOD SCOOP (See Fig. 5)
/
/
SEAT /
SWITCH
PAD _
SLOT /
7_
t
I
TAPE
WIRING HARNESS
Fig. 3
Push down on seat to engage pads in slots and pull
seat towards rear of tractor.
• Raise seat and tighten bolt securely.
• Remove tape and discard.
• Lower seat into operating position and sit on seat.
Press clutch/brake pedal all the way down. If operating
position is not comfortable, adjust seat.
TO ADJUST SEAT (See Fig. 4)
• Grasp adjustment handle and pull up, slide seat to
desired position and release adjustment handle.
SLOT TAPE
FLAT
WASHER
SEAT PAN
BOLT TAB
ADJUSTMENT
HANDLE
Fig. 5
®
®
Fig. 4
7