Filter
Top Products
SERVICE AND ADJUSTMENTS
TO LEVEL MOWER
Make sure tires are properly inflated to the PSI shown on
tires. If tires are over or under inflated, it may affect the
appearance of your lawn and lead you to think the mower
is not adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 29)
• With all tires properly inflated and ifyour lawn appears
unevenly cut, determine which side of mower iscutting
lower.
• With a 3/4" or adjustable wrench, turn lift link adjust-
ment nut (A) to the left to lower LH side of mower, or,
to the right to raise LH side of mower.
Turn nut rig Turn nut left
to raise mower to lower mower
Fig. 29
NOTE: Each full turn of adjustment nut will change mower
height about 3/16".
• Test your adjustment by mowing some uncut grass
and visually checking the appearance. Readjust, if
necessary, until you are satisfied with the results.
PRECISION SIDE-TO-SIDE ADJUSTMENT (See Fig. 30)
• With all tires properly inflated, park tractor on level
ground or driveway.
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap
blade with heavy cloth.
e
e
Raise mower to itshighest position.
At both sides of mower, position blade at side and
measure the distance (A) from bottom edge of blade
to the ground. The distance should be the same on
both sides.
AI L- W Lf IA
Fig. 30
21
• If adjustment is necessary, see step in Visual Adjust-
ment instructionsabove.
• Recheck measurements, adjust ifnecessary until both
sides are equal.
FRONT-TO-BACK ADJUSTMENT (See Fig. 31 & 32)
IMPORTANT: Deck must be level side-to-side.
Toobtain the best cutting results, the mower blades should
be adjusted so the front tip is 1/8" to 1/2" lower than the
rear tip when the mower is in its highest position.
i & CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap
blade with heavy cloth.
• Raise mower to highest position.
Position blade so the tip is pointing straight forward.
Measure distance (B) to the ground at front and rear
tip of the blade.
¢'_- e e
Fig. 31
If front tip of blade is not 1/8" to 1/2" lower than the
rear tip, go to the front of tractor.
With an 11/16" or adjustable wrench, loosen jam nut
A several turns to clear adjustment nut B.
With a 3/4" or adjustable wrench, turn front link adjust-
ment nut (B) clockwise (tighten) to raise the front of
mower, or,counterclockwise (loosen) to lower the front
mower.
TIGHTEN ADJUST LOOSEN
NUT B TO RAISE ADJUST NUT
MOWER ....... B TO LOWER
MOWER
LOOSEN JAM NUT A FIRST
Fig. 32
NOTE: Each full turn of the adjustment nut will change
mower height about 1/8".
• Recheck measurements, adjust ifnecessary until front
tip of blade is 1/8" to 1/2" lower than the rear tip.
• Hold adjustment nut inposition with wrench and tighten
jam nut securely against adjustment nut.