Filter
Top Products
5
2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting coverassembly
to tractor.
• Position cover assembly on ground behind tractor as
shown.
• Lift and rotate cover to align cover brackets with support
assembly tubes.
• Slide cover assembly down onto the support tubes.
FIG. 2
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
ASSEMBLY
1
BAGGER SUPPORT ASSEMBLY
(See Figs. 1A & 1B)
• Remove and discard the upper bolt on both sides of the
drawbar. Using the same holes, install the shoulder bolts
supplied and tighten securely.
DRAWBAR
SHOULDER
BOLTS
SUPPORT
ASSEMBLY
RETAINER
SPRING
PIN
FIG. 1A
REMOVE AND DISCARD
UPPER BOLTS AND INSTALL
SHOULDER BOLTS SUPPLIED
FIG. 1B
• Remove retainer spring from lower pin on support
assembly.
• Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
• Be sure support assembly is seated properly and secure
with retainer spring.