Filter
Top Products
6
ASSEMBLY
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment bolt or optional
knob.
• Remove cardboard packing on seat pan.
• Place seat on pan and assemble shoulder bolt.
• Assemble loosely adjustment bolt, lock washer and flat
washer (or knob, if so equipped). Do not tighten.
• Tighten shoulder bolt securely.
• Lower seat into operating position and sit on seat.
• Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down
(See Fig. 6).
• Get off seat without moving its adjusted position.
• Raise seat and tighten adjustment bolt or knob se-
curely.
SEAT PAN
FLAT
WASHER
SEAT
SHOULDER
BOLT
LOCK
WASHER
ADJUSTMENT
BOLT
KNOB
(IF SO EQUPPED)
FIG. 3
ACORN NUT
FIG. 4
HEX BOLT
LOCKNUT
TO INSTALL MULCHER PLATE
PREPARE MOWER DECK (See Fig. 4)
• Using holes provided in mower deck, install 5/16-18x1
hex bolts, 5/16-18 locknuts, and 5/16-18 acorn nuts.
• Install hex bolt from under mower deck and tighten
locknut securely. Assemble and tighten acorn nut on
hex bolt.
FIG. 5
SCREW
MULCHER
PLATE
LATCH
HOOK
HOOK
POINTS
DOWN
WELD NUT
FROM THE TOP
WELD
NUT
WASHER
WASHER
LOCK
WASHER
WELD
NUT
LATCH
HOOK
SCREW
LOCK
WASHER
ACORN NUT
LOCKNUT
INSTALL MULCHER PLATE (See Figs. 5 and 6)
• Install two latch hooks to mulcher plate using screw,
washer, lock washer, and weld nut as shown.
NOTE: Pre-assemble weld nut to latch hook by inserting
weld nut from the top with hook pointing down.
• Tighten hardware securely.
• Raise and hold deflector shield in upright position.
• Place front of mulcher plate over front of mower deck
opening and slide into place, as shown.
• Hook front latch hook onto hex bolt on front of mower
deck.
• Hook rear latch hook onto hex bolt on back of mower
deck.
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY (See Fig. 2)
• Lift seat pan to raised position and open battery box
door.
• If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in CUSTOMER RESPONSIBILITIES
section of this manual for charging instructions).
BATTERY
BOX DOOR
SEAT PAN
LABEL
TERMINAL
TERMINAL