Filter
Top Products
5
ASSEMBLY
TOOLS REQUIRED: 7/16" Wrench, Pliers,
Screwdriver
NOTE: Reference to Left or Right side of machine
is from the operator's position of the handle,
facing forward.
The lawn edger, except the handle and throttle
control, is fully assembled, packed, and shipped
in one container.
ATTACHING THE HANDLE
1. Remove handle brace, nuts, and bolts. Align
the handle, lower support, and handle brace
holes. Use all six nuts and bolts. Leave bolts
loose until Steps 2 and 3 are completed (See
Fig. 1).
2. Install control rod into upper and lower pivot
holes and secure with cotter pins (See Fig.
1). Oil pivots lightly before installing rod.
3. Move clutch-depth lever into rear notch of
quadrant on handlebards. Move cutterhead
angling lever to top notch of quadrant.
4. Remove spark plug wire from spark plug.
Move throttle to OFF position. Check clutch
operation by pulling recoil starter rope. If
blade turns when depth lever is in top notch,
loosen handle bolts and pull toward operator.
Snug bolts and check clutch operation again.
— IMPORTANT NOTE —
Make sure blade does not turn when lever is in
top notch (disengaged).
5. Slip on the handle grips.
6. Tighten bolts.
FILL ENGINE WITH OIL
NOTE: There is no oil in engine crankcase.
1. Follow instructions in the engine manual for
correct grade of oil, oil lling, and oil changing.
2. Do not mix oil with gasoline.
INSTALLING THE THROTTLE WIRE
1. If the throttle cable is not attached to the
engine carburetor, follow the instructions in
the engine operating manual. Some throttle
cables cannot be attached before shipping.
Check oil level of engine every time edger-
trimmer is used. An improper oil level can cause
extensive internal damage to engine.
FUEL SPECIFICATION
1. Follow fueling instruction in the engine
manual.
Handle fuel with care — it is highly ammable.
Use only approved fuel container. Never add
fuel while engine is running. Fill fuel tank
outdoors, with extreme care. Never ll fuel
tank indoors. Replace gasoline cap securely
and wipe up all spilled fuel.
CAUTION
Always clean area around fuel cap before
removing it to prevent excessive amounts of dirt
from entering fuel system. Also insure that the
fuel storage container you are using is clean and
in good condition.
CORRECT ENGINE OPERATION
Before starting engine, become familiar with
all controls. Read this Operator's Manual
thoroughly. Always check engine oil level
before starting engine.
CAUTION
Care should be taken to avoid inhaling ex-
haust gasses, as they contain carbon mon-
oxide gas, which is colorless and oderless.
Carbon monoxide is a dangerous gas that
can cause unconsciousness and is poten-
tially lethal. Do not run engine in conned
areas such as closed garages.
WARNING
Fig. 1
Throttle Cable
Throttle
Cable Clip
Install 6 Bolts Through
Handle Lower Support
& Handle Brace Holes
Control Rod