Husqvarna HUV 4414 Utility Vehicle User Manual


 
Driving Instructions
11. Release the brake pedal completely, and then slowly press the accelerator pedal. As the accelerator pedal is
pressed, the vehicle will begin to move. Vehicle speed will increase as the accelerator is pressed until full speed
is reached. See following WARNING.
WARNING
Operator must control vehicle speed when going downhill.
Never shift the vehicle out of the FORWARD position while going downhill. If you do, you will not be
able to shift into the REVERSE position or back into the FORWARD position until stopped.
Press the brake pedal as necessary and press the accelerator pedal partially when descending a hill.
With the accelerator pedal partially pressed, the governor will cause the engine to assist the brakes in
controlling downhill speed.
DRIVE TRAIN OPERATION
The 4X2 vehicle features a drive train with a locking rear differential. The 4X4 vehicle also features an open front
differential. In normal operation, the rear differential drives the two wheels at varying speeds as required. Under
conditions with low traction, the differential lock may be engaged allowing both wheels to become locked and drive
at the same speed. On the 4x4 vehicle, the front differential may also be engaged to provide additional traction in
slippery conditions. See following WARNING.
WARNING
When servicing the vehicle with part of the vehicle on jack stands, do not operate the engine with the
Forward/Reverse handle in either the FORWARD or REVERSE position. The four-wheel drive system
may engage any wheel(s), front or rear, depending on the mode selected. See (Figure 3).
The diameter of all tires on the vehicle must be equal; otherwise the four-wheel drive system will not
operate as intended and could result in severe personal injury or death. Never install tires of different
diameters on the vehicle.
Reduced steering control can occur when the front differential is locked.
STOPPING THE VEHICLE
To stop the vehicle, release the accelerator pedal and press the brake pedal until the vehicle comes to a complete stop.
See following WARNING and CAUTION.
WARNING
Driving through water may affect the brakes. After driving through water, check effectiveness of the
brakes by gently pressing the brake pedal. If the vehicle does not slow down at the normal rate,
continue to press the brake pedal until the brakes dry out and normal performance returns.
CAUTION
When stopped on a hill, use the brake pedal to hold your position. Do not use the accelerator pedal
to hold position.
2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Page 23