Husqvarna HUV 4414 Utility Vehicle User Manual


 
Seat Latch and Adjustment
WARNING
Do not operate the vehicle if the ROPS is damaged. If the ROPS is damaged, replace the structure.
Do not attempt repair.
The driver and passenger must be restrained at all times with the seat belts provided to help prevent
injury in the event of sudden braking, collision, or roll-over.
In the event of a roll-over, do not attempt to jump or otherwise exit the vehicle. Remain seated with
seat belt fastened and with arms and legs inside the vehicle.
After inserting the tab, make sure the tab and buckle are locked and that the belt is not twisted.
Loose tting seat belts could increase the chance of injury due to sliding under the belt if sudden
braking should occur. Keep the seat belt snug and positioned as low on the hip bone as possible.
Use a single seat belt for one person at a time. Do not use a single seat belt for two or more people
this includes children.
No more than two persons per bench seat at one time. Do not allow people to ride in any part of the
vehicle that is not equipped with a seat and a seat belt. Do not allow a passenger to hold a child in his
or her lap while the vehicle is moving.
This vehicle is not designed to meet child seat compatibility requirements. Children requiring a child
safety seat must not ride on the vehicle. Comply with state and local laws pertaining to child safety.
CAUTION
Be careful not to damage the seat belt webbing or hardware.
Inspect the seat belt system periodically. Check for cuts, fraying, and loose parts. Damaged parts
should be replaced immediately. Do not disassemble or modify the system.
Keep seat belts clean and dry. If cleaning is necessary, use a mild soap and lukewarm water solution.
Do not use bleach, dye or abrasive cleaners as they may severely weaken the seat belts.
Do not insert coins, clip, etc. in the buckle as this may prevent the tab from locking into the buckle
properly.
If the seat belt does not function normally, contact your dealer/distributor or trained technician
immediately. Do not occupy the seat until the seat belt is repaired.
SEAT LATCH AND ADJUSTMENT
The vehicle seat(s) are hinged to allow easy access to the engine compartment. To raise the seat bottom, grasp the
rear side of the seat bottom, and pull rmly in a forward/upward direction. See following WARNING.
WARNING
Make sure seat hinges and latches are securely engaged before operating the vehicle.
2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Page 19