Filter
Top Products
1. Fit the lower handle (E1) to the deck with the lower
handle pin (E2) as illustrated in Fig E.
2. Attach the wheels (F1) to the wheel frame (F2) with the
wheel retaining clips (F3) as illustrated in Fig F.
3. Fit the wheel frame (G1) to the deck with the lower
handle bolt (G2), small washer (G3), large washer
(G4) and locknut (G5) as illustrated in Fig G.
4. Locate the lower telescopic tubes (H1) inside the upper
telescopic tubes (H2) and secure with the pin (H3) and
retaining clip (H4) as illustrated in Fig H.
Fit the Upper Handle to the Lower Handle by following
the instructions above in ‘Assembly (without wheels)’
section.
Handle Position
The handle position can be adjusted using the guide
and hook assembly.
1. Lift hook (C1).
2. Position as required:
(C2) Parking position
(C3) Mowing position
Assembly (with wheels)
G
H
1
3
1
2
3
4
5
1
2
1
2
3
4
2
F
E
1
2
Fuel
Use a fresh, clean, unleaded regular automotive gasoline
Do not
fill thefuel tankinan enclosedarea, when the engine is
hotorwhileyouaresmoking or near a naked flame. Thoroughly
clean around the fuel tank filler cap before filling, this will help to
prevent dirt being introduced into the fuel system. Fuel should
be stored in a cool place away from naked flames. Do not fill
the tank while the engine is running. Fill the fuel tank through a
funnel fitted with a fine filter. Never fill fuel tank completely, only
fill to the base of the filler neck. When filling the fuel tank from
empty, or when the engine has previously run dry, a minimum of
400cc of fuel must be added (to the level of the line indicated
in diagram J) to ensure correct priming of the fuel pump to start
the engine. Your carburettor is pre-set. Normally no further
adjustment is required.
Oil
Use 4-stroke automotive detergent oil. SAE 10W-30
is recommended for general use.
Fill with oil as instructed in your Engine Owners
Manual provided with your product.
J
4