Filter
Top Products
65
6
To Level Mower
Make sure tires are properly infl ated to the PSI shown on tires.
If tires are over or under infl ated, it may affect the appearance
of your lawn and lead you to think the mower is not adjusted
properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
1. With all tires properly infl ated and if your lawn appears un-
evenly cut, determine which side of mower is cutting lower.
NOTE: As desired, you can raise the low side of mower or
lower the high side.
2. Go to side of mower you wish to adjust.
3. With a 3/4" or adjustable wrench, turn lift link adjustment
nut (A) to the left to lower the mower, or, to the right to raise
the mower (Fig. 1).
NOTE: Each full turn of adjustment nut will change mower
height about 3/16".
4. Test your adjustment by mowing some uncut grass and
visually checking the appearance. Readjust, if necessary,
until you are satisfi ed with the results.
PRECISION SIDE-TO-SIDE ADJUSTMENT
1. With all tires properly infl ated, park tractor on level ground
or driveway.
CAUTION: Blades are sharp. Protect your hands with
gloves and/or wrap blade with heavy cloth.
2. Raise mower to its highest position.
3. At both sides of mower, position blade at side and measure
the distance (A) from bottom edge of blade to the ground.
The distance should be the same on both sides (Fig. 2).
4. If adjustment is necessary, see steps 2 and 3 in Visual
Adjustment instructions above.
5. Recheck measurements, adjust if necessary until both
sides are equal.
0
2
9
4
8
A
02473
02473
Fig. 1
02966
A
A
Fig. 2
02548
B
B
Fig. 3
B
02950
A
02473
02473
B
Fig. 3
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to-side.
To obtain the best cutting re sults, the mower blades should be
adjusted so the front tip is 1/8" to 1/2" lower than the rear tip
when the mower is in its highest position.
CAUTION: Blades are sharp. Protect your hands with
gloves and/or wrap blade with heavy cloth.
• Raise mower to highest position.
• Position any blade so the tip is pointing straight forward.
Measure distance (B) to the ground at front and rear tip of
the blade (Fig. 3).
• If front tip of blade is not 1/8" to 1/2" lower than the rear tip,
go to the front of tractor.
• With an 11/16" or adjustable wrench, loosen jam nut A sev-
eral turns to clear adjustment nut B.
• With a 3/4" or adjustable wrench, turn front link adjustment
nut (B) clockwise (ltighten) to raise the front of mower, or,
counterclockwise (loosen) to lower the front mower (Fig. 4).
NOTE: Each full turn of the adjustment nut will change mower
height about 1/8".
• Recheck measurements, adjust if necessary until front tip of
blade is 1/8" to 1/2" lower than the rear tip.
• Hold adjustment nut in position with wrench and tighten jam
nut securely against adjustment nut.