Filter
Top Products
26
OPERATION
Starting and cutting with machine:
• Using Blade Depth Control (EE), raise Diamond Blade
(H) as high as possible so it will not strike pavement
when maneuvering. Pull out on Blade Depth Stop (FF) if
required.
• Dis-engage Parking Brake (OO) by moving Transmis-
sion Engagement Lever (PP) rearward to Dis-Engaged
position.
• With engine OFF, maneuver machine into position near
line to be cut.
• Lower Front Pointer (A) onto cutting surface.
• Set Depth Indicator (GG) (use if desired):
1) Lower machine until diamond blade contacts cut-
ting surface.
2) Set Depth Indicator (GG) dial to align indicator
arrows with zero (0). Orange color indicates cutting
depth in centimeters. White color indicates inches.
3) Raise saw to maximum height. Now as Diamond
Blade (H) is lowered, Depth Indicator (GG) will
show cutting depth.
4) Fully raise Diamond Blade (H).
Starting FS 513:
• Verify that Emergency Stop Switch (AA) AND Engine
Start Switch (DD) are in “ON” position. Emergency Stop
Switch (AA) should be in outer position (pulled outward
from cowl). Engine Start Switch (DD) must be turned to
“1” (ON) position. Travel Speed Lever (QQ) is near the
“Stop” position.
• Start Engine by engaging Engine Choke Lever, and pull-
ing starting rope. Dis-engage Engine Choke Lever after
engine starts. See engine manual for more information.
Starting FS 520 / FS 524:
• Verify that Emergency Stop Switch (AA) is in outer posi-
tion (pulled outward from cowl), and Parking Brake (OO)
is dis-engaged [Transmission Engagement Lever (PP)
moved rearward to Dis-Engaged position]. Travel Speed
Lever (QQ) is near the “Stop” position.
• Pull Engine Choke Outward (See engine manual for
more information).
• Turn Engine Start Switch (DD) to “Start“ position.
• Start Engine. See engine manual for more information.
After Starting Engine (All Models):
• Visually verify that tool rotation matches directional ar-
row on blade guard.
• Open Water Control Valve (KK1) FULL open. Verify full
water ow, and then adjust for proper amount of water on
the blade BEFORE you lower the Blade.
• Make nal adjustments to align saw with cutting line.
Verify that Guide Wheel (B), and Diamond Blade (H) are
both on the cutting line.
NOTICE
Parking Brake must be dis-engaged to start engine (FS
520 & FS 524). Move Transmission Engagement Lever
(PP) rearward to Dis-Engaged position.