Husqvarna CTH2542T Lawn Mower User Manual


 
7
ASSEMBLY
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
Remove adjustment knob and flat washer securing
seat to cardboard packing and set aside for assembly
of seat to tractor.
Pivot seat upward and remove from the cardboard pack-
ing. Remove the cardboard packing and discard.
Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten.
Lower seat into operating position and sit on seat.
Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down.
Get off seat without moving its ad just ed position.
Raise seat and tighten adjustment knob securely.
Fig. 3
0
2466
02464
SEAT PAN
SHOUL DER BOLT
AD JUST MENT KNOB
FLAT
WASH ER
SEAT
NOTE: You may now roll your tractor off the skid. Follow
the ap pro pri ate instruction below to remove the tractor
from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op er a tion
section for location and function of con trols)
Press lift lever plunger and raise attachment lift lever
to its highest po si tion.
Release parking brake by de press ing clutch/brake
ped al.
Place freewheel control in "trans mis sion dis en gaged
position" (See “TO TRANS PORT” in the Op er a tion
section of this manual).
Roll tractor forward off skid.
Remove banding holding the deflector shield up against
tractor.
Continue with the instructions that follow.
Fig. 4B
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
Install the two upper support brack ets through the back
plate and to the chas sis, install the clevis pin 10x17mm
and secure with retainer spring.
Assemble both support brackets to the outside of the
bagger support tube using two each 3/8 x 63,5mm hex
bolts13/32" I.D. flat washers and 3/8 locknuts from parts
bag. Tight en securely.
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
02330
SUP PORT
TUBE
FLAT
WASHER
3/8 NUT
BOLT
Fig. 4C
02590
CLEVIS PIN 10 X 17MM
3/8 LOCK NUT
SUPPORT BRACKET
10,3MM (13/32")
FLAT WASHER
3/8 X 63,5MM HEX BOLT
RETAINER SPRING
Fig. 4A
TO INSTALL BAGGER COM PO NENTS TO
TRAC TOR (See Figs. 4A-4D)
Remove discharge chute from rear of tractor. Unhook the
two (2) straps and pull chute out and away from tractor.
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
02
277
DISCHARGE
CHUTE
3/8 NUT
FLATWASHER