Filter
Top Products
23
SERVICE AND ADJUSTMENTS
TRACTOR
TO REMOVE MOWER (See Fig. 25)
Mower will be eas i er to re move from the right side of trac-
tor.
• Place attachment clutch control in “DISENGAGED”
po si tion.
• Move attachment lift lever forward to lower mower to
its lowest position.
• Roll belt off clutch pulley.
• Disconnect anti-sway bar from chassis bracket by
re mov ing re tain er spring.
• Disconnect suspension arms from rear deck brackets
by removing retainer springs.
• Disconnect front links from deck by removing retainer
springs.
• Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER
DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE
FRONT LINKS.
TO INSTALL MOWER (See Fig. 25)
Be sure tractor is on level surface and mower suspension
arms are raised with attachment lift control. Engage park-
ing brake.
• Slide mower under tractor.
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
• Install belt into clutch pulley groove.
• Install left front link into the left hand front mower bracket
(retain with single loop retainer springs as shown).
• Slide right side of mower back and install right front link
into right hand front mower bracket (retain with single
loop retainer springs).
• Place the suspension arms on mower pins, if nec es-
sary, rock and raise front of mower to align mower pins
with the holes in suspension arms. Retain with double
loop retainer spring, loop down as shown.
• Connect anti-sway bar to chassis bracket under left
footrest and retain with double loop retainer spring.
• Raise deck to highest position.
Fig. 25
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS:
• Depress clutch/brake pedal fully and set parking brake.
• Place motion control lever in neutral (N) position.
• Place attachment clutch in “DISENGAGED” position.
• Turn ignition key to “STOP” and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
ANTI SWAY
BAR
RETAINER
SPRING
RETAINER
SPRING
SUSPENTION
ARMS
CLUTCH PULLEY
FRONT LINKS
RETAINER
SPRINGS