Filter
Top Products
8
FIG. 4D
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the dis charge chute to fl oat with the
mower deck when moving on uneven terrain.
02306
HOOK
BACKPLATE
SLOT
DIS CHARGE
CHUTE
0259
2
LOWER
BAGGER
TUBE
FRONT BAGGER TUBE
1/4 X 2"
CARRIAGE
BOLTS
1/4 LOCK
NUT
FIG. 5
TO ASSEMBLE BAGGER (See Figs. 5 & 6)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person when putting the bagger
to geth er.
• Holes in front bagger tube are at an angle. Place front
bagger tube against lower bagger tube and check for
proper hole alignment before assembling bolts.
• Assemble front and lower bagger tubes using four (4)
1/4 x 50,8mm carriage bolts and lock nuts supplied.
Tighten se cure ly.
• Slide front and lower bagger tube assembly into the
bagger assemby.
• Assemble front and upper bagger tubes using four (4)
1/4 x 50,8mm carraige bolts and lock nuts supplied.
Tighten se cure ly.
• Slip all the vinyl bindings over the bagger tubes.
• Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin and secure with retainer
spring.
• Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in
order to use the handle to clear the chute in the event it
has become clogged.
ASSEMBLY
FIG. 4A
FIG. 4B
TO INSTALL BAGGER COM PO NENTS TO
TRAC TOR (See Figs. 4A-4D)
• Remove discharge chute from rear of tractor. Unhook
the two (2) straps and pull chute out and away from
tractor.
• Remove the two (2) 3/8 nuts and fl at washers from the
bolts at the tractor back plate.
• Using the nuts and fl at washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
• Install the two upper support brack ets through the
back plate and to the chas sis, using the 10 x 19 mm
(3/8"x3/4") carriage bolts and locknuts sup plied. Tight en
se cure ly.
• Assemble both support brackets to the outside of the
baggger support tube using two each 3/8 x 63,5mm
hex bolts13/32" I.D. fl at washers and 3/8 locknuts from
parts bag. Tight en securely.
• Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
0
2277
DISCHARGE
CHUTE
3/8 NUT
FLATWASHER
02330
SUP PORT
TUBE
FLAT
WASHER
3/8 NUT
BOLT
FIG. 4C
02590
3/8 LOCK NUT
3/8 LOCK NUT
SUPPORT BRACKET
13/32 FLAT
WASHER
3/8 HEX BOLT
3/8 CAR RIAGE BOLT