Husqvarna CT16 Brush Cutter User Manual


 
3
Record the following information about your unit so that you will be able to provide it in case of loss or theft.
CITY:
STATE: TELEPHONE:
PURCHASE DATE:
MODEL NUMBER:
/
/
SERIAL NO.:
CODE NO.:
(Enter complete 8 digit number from model plate on unit)
DEALER'S NAME AND ADDRESS:
WARNING: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may
have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine
authorized service dealer.
1 - Shut-Off Switch and Parts
California Proposition 65 WARNING!
The engine exhaust from this product contains chemicals known to the State of
California to cause cancer, birth defects or other reproductive harm.
SAFETY RULES ...................................................2
TABLE OF CONTENTS ...................................... 3
OWNER'S INFORMATION .................................. 3
CONTENTS OF PARTS BAG .............................. 3
ASSEMBLY ....................................................... 4-5
OPERATION ..................................................... 6-9
MAINTENANCE ............................................ 10-11
SERVICE AND ADJUSTMENTS................... 12-13
STORAGE ...........................................................14
TROUBLESHOOTING ....................................... 15
REPAIR PARTS ............................................ 16-21
WARRANTY ......................................... Back Cover
CONTENTS OF SHIPPING CARTON
1 - 10 inch Tiller/Cultivator completely assembled
except for the handles and throttle control assembly
1 - Upper Handle
1 - Left Hand Lower Handle
1 - Right Hand Lower Handle
1 - Owner's Manual (Not Shown)
1 - Bag of Assembly Parts (See below)
TOOLS REQUIRED FOR ASSEMBLY
2 - 7/16 inch Wrenches (or adjustable wrenches)
1 - Regular Screwdriver
1 - Pair Scissors
TO REMOVE TILLER/CULTIVATOR
FROM CARTON
Remove plastic parts bag for tiller/cultivator from
carton.
Remove handles from the carton.
Remove remainder of packing material from carton.
Lift the tiller/cultivator out of carton and place on
a hard, level surface.
Remove packing material from around tines.
CONTENTS OF PARTS BAG (shown actual size)
1 - 10-16 x 1-1/2 Inch
Washer Head Tap Screw
1 - Tie Strap
OWNER'S INFORMATION
TABLE OF CONTENTS
PARTS
PARTS BAG