Filter
Top Products
English-61
LUBRICATION
12. Belt Adjuster, Hydraulic Pumps
Lubricate using a grease gun, one zerk, until
the grease squeezes out.
Use only good quality molybdenum
disulphide grease.
Grease from well-known brand names
(petrochemical companies, etc.) usually
maintains
a good quality.
13. Changing the Oil Filter
1. Drain the engine oil in following the
procedure in the section, Engine Oil/
Change Engine Oil.
2. Disassemble the oil filter. If necessary,
use a filter remover.
3. Partially fill the new filter with oil.
4. Wipe new, clean engine oil onto the seal
for the new filter.
5. Mount the filter by hand with + 3/4 turn.
6. Run the engine warm, then check that
there are no leaks around the oil filter
seal.
7. Check the oil level in the engine, top off if
necessary.
BAM-24
Lubricating the belt adjuster
IMPORTANT INFORMATION
Use minimal lubrication and remove excess
lubricant so that is does not come into
contact with belts or belt pulley drive
surfaces.
BAM-23
Changing the oil filter