Filter
Top Products
32
MAINTENANCE
Replacing the Air Filter
If the engine seems weak or runs unevenly
and the dust load indicator has turned red the
air filter may be clogged. If run with a clogged
air filter, disruption of operation can occur.
Cleaning/replacing the air filter is carried out
as follows
Only do so when the dust indicator is red.:
1. Unfasten the two plastic clamps on the
sides of the air filter cover. Remove the
air filter cover.
2. Remove the paper filter. Lightly brush or
use mild air pressure to clean
3. Only remove and replace safety element
after the paper filter has been replaced 3
or 4 times.
4. Refit the air filter as follows:
Check that the seal on the bottom of the
paper filter is whole.
Mount the safety element in the air filter
housing.
5. Place the paper filter over the safety
element.
6. Replace the cover over the air filter
housing. Fasten the two plastic clamps
making sure the cover is snapped into
position.
7. Push top of dust load indicator to reset it.
Remove the air filter cover
CLAMP
CLAMP
BAM-15
DUST LOAD INDICATOR
WARNING!
Allow the exhaust system to
cool before performing
service. Risk for burns.
Paper filter
BAM-16
IMPORTANT INFORMATION
Do not use compressed air to clean the air
filter.
Do not wash the paper filter.
Do not oil the paper filter. Do not tap filter
to clean this could cause damage to the
sealing.
Safety element
BAM-17