Husqvarna BZ6127D Lawn Mower User Manual


 
24
OPERATION
3. Select the cutting height by placing the
pin in one of the holes. Lock the pin on
the inside with the cotter pin.
4. Press in the stop handle, counter hold,
and carefully move the lifting lever
forward from the transport position
toward the pin on manual units.
5. On power units push the hydraulic lift
switch forward to lower the deck to the
selected pin position.
6. Engage the mower deck by pulling out
the control knob.
7. The machine’s speed and direction are
continuously variable using the two
motion control levers. The motion control
levers can be moved forward or
backward about a neutral position.
Furthermore, there is a neutral position,
which is locked if the motion control
levers are moved outward into the
neutral slots.
When both controls are in the neutral
position (N), the machine stands still.
The motion control levers on each side of
the mower control the direction of
movement. The left lever controls the
flow of oil from the left hydro pump to the
left wheel motor. The right lever controls
the flow of oil from the right hydro pump
to the right wheel motor.
NOTE: To begin motion, the operator must be
in the seat and the parking brake disengaged
8011-561
Cutting height selection (27.5 HP )
IMPORTANT INFORMATION
The mower deck’s anti-scalp rollers should
be evenly adjusted. See Maintenance
section
WARNING!
Make sure that no one is near
the machine when engaging
the mower deck.
Engaging the mower deck
BAM-2
Hydraulic switch
BAM-2