Filter
Top Products
GB-17
G
B
BCZ3205DL / BCZ3205DW
(1)
10. Storage
Aged fuel is one of major causes of engine starting fail-
ure. Before storing the unit, empty the fuel tank and run
the engine until it uses all the fuel left in the fuel line and
the carburetor. Store the unit indoor taking necessary
measures for rust prevention.
9. Maintenance
11. Disposal
• When you dispose of the machine, do not disas-
semble the machine.
• When you dispose of the machine, fuel, oil, be sure
to follow your local regulations.
INTAKE AIR COOLING VENT
WARNING
• Check the intake air cooling vent after every 25
hours of use for blockage, and remove any waste
which has attached itself to the brushcutter.
IMPORTANT
• If waste gets stuck and causes blockage around the
intake air cooling vent, it may cause the engine to
overheat, and that in turn may cause mechanical fail-
ure on the part of the machine.
MUFFLER
WARNING
• Inspect periodically, the muffler for loose fasten-
ers, any damage or corrosion. If any sign of ex-
haust leakage is found, stop using the machine
and have it repaired immediately in the repair spe-
cialty store.
• Note that failing to do so may result in the engine
catching on fire.
SPARK ARRESTER
• The muffler is equipped with a spark arrester to pre-
vent red hot carbon from flying out of the exhaust out-
let. Periodically inspect and clean as necessary with
a wire brush in the repair specialty store.
(1) Spark arrester
ANGLE TRANSMISSION
• The reduction gears are lubricated by multipurpose,
lithium-based grease in the angle transmission. Sup-
ply new grease every 25 hours of use or more often
depending on the job condition.
• Remove the bolt opposit to the grease nipple before
installing new grease to arrange for old grease to exit.
Intake air cooling vent