Filter
Top Products
GB-13
G
B
BCZ3205DL / BCZ3205DW
ADJUSTING THROTTLE CABLE
• The normal play is 1 or 2 mm when measured at the
carburetor side end. Readjust with the cable adjuster
as required and tighten the screw up.
ADJUSTING IDLING SPEED
(1) Idle speed adjuster
1. When the engine tends to stop frequently at idling
mode, turn the adjusting screw clockwise.
2. When the cutting head keeps rotating after releasing
the throttle trigger, turn the adjusting screw counter-
clockwise.
NOTE
•Warm up the engine before adjusting the idling speed.
CUTTER APPLICATION CHART
• Replace by a suitable recommended cutting attach-
ment according to the object to be cut.
• When replacing blade always be sure to use products
which have been certified by ZENOAH.
WARNING
• When sharpening, removing, or reattaching the blade,
be sure to wear thick, sturdy gloves and use only
proper tools and equipment to prevent injury.
8. Operation
(1)
METAL BLADE USAGE
1. Check the nut to fasten the blade and be sure the nut
has no fault, and no abrasion.
2. Be sure that the blade and the holder have been fas-
tened according to instruction and the blade turns
smoothly without abnormal noise.
WARNING
• The rotating parts fastened incorrectly may
cause serious accident to the operator.
• Make sure that the blade is not bent,
warped, cracked, broken or damaged.
• If you find any error to the blade, discard it
and change new one which is certified by
ZENOAH.
• By using the harness, hang the unit on your right side.
Adjust the harness length so that the cutting head
may become parallel to the ground.
WARNING
• Make sure to use harness and cutting at-
tachment guard. If not, it is vary dangerous
when you slip or lose your balance.
848-BU3-6914
848-8Z2-3011
(1)
(3)
(2)
(1) Cable adjuster
(2) 0.04in (1~2mm)
(3) Screw