Husqvarna AP1720-E2 Lawn Mower User Manual


 
5
UNASSEMBLED PARTS
(2) Keys
Slope Sheet
Key
(1) Oil Drain Tube
ASSEMBLY
When right or left hand is mentioned in this man ual, it means when you are in the operating po si tion (seated be hind the
steer ing wheel).
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.
FIG. 1
ADJUST SEAT (See Fig. 2)
Sit in seat.
Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
Release lever to lock seat in position.
FIG. 2
A
02021
BATTERY
BOX DOOR
SEAT PAN
LABEL
TERMINAL
TERMINAL
CHECK BATTERY (See Fig. 1)
Lift seat pan to raised position and open battery box
door.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual
for charging in struc tions).
NOTE: You may now roll or drive your tractor off the skid.
Follow the ap pro pri ate instruction on the next page to
remove the tractor from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
UNPACK CARTON
Remove all accessible loose parts and parts cartons
from carton.
Cut along dashed lines on all four panels of carton.
Remove end panels and lay side panels flat.
Check for any additional loose parts or cartons and
remove.
TO REMOVE TRACTOR FROM CAR TON