Husqvarna 968999271 Lawn Mower User Manual


 
16
SETUP AND ADJUSTMENTS
Adjustments
Cutting Height
Stop the mower and disengage the blades.
Raise the deck height lever to the transport posi-
tion.
Remove the height adjustment pin and place it in
the desired cutting height hole. Lower the lift lever
down onto pin. NOTE: Anti-scalp rollers must be
in the proper position for maximum deck floata-
tion. See the decal on the front deck for proper
settings. FIG - 5
Lift Lever
Deck Height
Adjustment
Plates
Motion
Control
Lever
Control
Arm
“F” Full
Mark
Operating
Range
FIG - 1
FIG - 2
FIG - 3
Control Arms
Remove top bolt in control arm and loosen bot-
tom bolt, rotate the control levers to the upright
position. Align the levers so they are even in the
neutral position. Reinstall hardware and tighten.
FIG - 1
Seat Install
1. Remove seat assembly from the crate.
2. Remove the four 5/16C nyloc nuts or 5/16C
studed knobs from the bottom of the seat.
Retain for use later.
3. Align the seat bottom with the holes in the seat
frame. Place seat on top of the seat frame
and secure with the four nuts or knobs re-
moved in step 2.
4. Connect the wire harness from the seat to the
frame harness.
Engine Oil
Check engine oil with dip stick. Add if needed per
the engine manufactures specifications. See en-
gine manual for oil type and filling specifications.
FIG - 2
Loosen the discharge chute slightly and lower into
position. Chute should be snug but still pivot freely.