Husqvarna 968999271 Lawn Mower User Manual


 
15
SETUP AND ADJUSTMENTS
Setup
Uncrate machine.
WARNING!
No settings or adjustments are to be
made unless: Engine is stopped, key has
been removed, park brake is on and bat-
tery cable removed from battery.
ROPS Assembly
(Roll Over Protection System)
ROPS Assembly Components
1 - Top Loop
1 - Left Side Post
1 - Right Side Post
1 - Hardware Bag
2 - 1/2” Latch Pins w/lanyard
2 - 1/2C x 3 1/4” Cap screws
6 - 1/2C Centerlock Nuts
4 - 1/2C x 4” Cap screws
2 - Knobs
(all hardware Grade 5).
1. Remove roll bar and parts bag from the box.
2. Install roll bar side posts.
a. Locate the LEFT and RIGHT side posts.
b. Slilde the left side post into the left side
receiver on the frame, do the same on
the right side.
c. Using 1/2C x 3 1/4 cap screws, two per
post, align the holes in the side post with
the frame receiver.
d. Install the 1/2C centerlock nuts finger tight
to the side post bolts.
3. Install roll bar top loop.
a. Align the holes of the top loop with the left
and right side posts.
b. Slide the latch pins thru the front hole on
the left and right side to connect the top
loop to the side posts and secure with the
hairpin.
c. Using 1/2C x 3 1/4 cap scrws thru the
rear hole on the left and right side.
d. Install the 1/2C centerlock nuts finger
tight.
4. Torque all 1/2” hardware to 80 ft./lbs. (110 N•m).
5. Install and tighten knobs against the side
post.
LATCH PIN
1/2C X 3 1/4
CAPSCREW
KNOB
1/2C CENTERLOCK
NUT
LEFT SIDE
POST
RIGHT SIDE
POST
TOP LOOP
1/2C CENTERLOCK
NUTS
1/2C X 4”
CAPSCREWS
Mount rear drive wheels using the lug nuts installed
on the hubs.
Check the tire pressure in all four tires. All tires
should be 15 psi.
Tires