Filter
Top Products
CONTROLS
Husqvarna-15
8062-006
Recoil starter grip
IMPORTANT INFORMATION
Do not let recoil cord snap back by itself. This
may damage the cord or the recoil starter
assembly.
8062-003
Ignition key
8062-004
Drive levers
Drive Levers
The machine’s speed and direction are continuously
variable using the two motion control levers.
By releasing both controls an equal amount the
machine moves in a straight line forward.
In order, for example, to turn right while moving
forward, squeeze the right control upward toward
the handle (neutral position). The rotation of the right
wheel is reduced and the machine turns to the right.
To stop forward travel, pull both drive levers up into the
neutral position.
When both controls are in the neutral position, the
machine stands still. The controls will be locked in
neutral position when both neutral locks are engaged.
Ignition Switch
The ignition key switch is located on the control panel
at the lower right.
Recoil Starter Grip
Pull the recoil starter grip slowly until you feel
compression, then pull it briskly.
Normally this engine will not backre. If you get
backres, contact your Husqvarna dealer for service.
WARNING!
The machine can turn very rapidly if
one steering control is moved much
further forward than the other.