Filter
Top Products
English – 119
NOTE!
Ensure excess gasket material does
not fall into the crankcase.
Other saws.
Fit the crankcase bolts. Tighten crosswise
with the torque set out in the ”Service data”.
Tighten the bolts closest to the crankshaft
first.
Cut off excess gasket at the level of the
cylinder seating plane.
On saw 394, fit the floor of the carburettor
chamber using the four bolts.
Fit the following parts
A. Chain and bar. See
operating instructions.
B. Starter. See page 59.
C. Electrical system. See page 63.
D. Centrifugal clutch. See page 69.
E. Oil pump. See page 77.
F. Carburettor.
G. Muffler. See page 49.
H. Piston and cylinder. See page 111.
I. Tank unit. See page 105.
CRANKCASE AND CRANKSHAFT
A
B
Saw 40 and 45.
See next page.
If a crankshaft has been fitted the saw must
be run-in for 3-4 hours with the carburettor
set to the basic settings.
See the operating instructions.
Eng, p 83-124 96-09-13, 11.38119