Filter
Top Products
ENGLISH -
OPERATION
CONNECTION V220/230 - 50 Hz
VERSION MANUAL LAWN MOWER
Before connecting up the lawn mower to the electric power
supply, make sure that the mains supply voltage is 220-
230V/50Hz and that a ground fault interrupter is installed
on the mains circuit. Start the mower as follows:
a) Press the safety push-button (5) to enable mower
startup.
b)Start the mower by pulling the lever (11) towards the
handle and keeping it pressed down. If you release the
lever, the motor will stop.
ATTENTION MOTOR PROTECTOR
A motor cut -out device (motor protector) has been
incorporated in the switch. Therefore, when reaching
excessive cutting stress or overload, the motor will cut
out automatically.
For re-starting, wait until the motor will be cool (approx.
5 to 10 minutes);
MOWING
To cut the grass, push the lawn mower manually
VERSION SELF-PROPELLED
Before connecting up the lawn mower to the electric power
supply, make sure that the mains supply voltage is 220-
230V/50Hz and that a ground fault interrupter is installed
on the mains circuit. Start the mower as follows:
a) Press the safety push-button (5) to enable mower
startup.
b)Start the mower by pulling the lever (11) towards the
handle and keeping it pressed down. If you release the
lever, the motor will stop.
MOWING
To cut the grass, push the lawn mower manually or insert
the automatic advance gear.
How to insert automatic advance: Lift up the clutch lever
(13) and keep it pressed in position.
How to disengage advance: Release the clutch lever.
ADJUSTMENT OF CLUTCH CABLE (for self-propelled versions only)
Important: If, when you press the clutch lever, the automatic advance gear does not engage, the clutch cable
should be adjusted by inserting the spring (P) in one of the subsequent holes (S) in the clutch lever (13).
AUTOMATIC ADVANCEMENT (for self-propelled versions only)
Periodically check the automatic advance assem-
bly and make sure to keep it clean. In particular,
the pinion (15) and the gear (16) must be kept
perfectly clean.
MAINTENANCE
l Frequently check the mower and ensure that all grass
deposits are removed from beneath the deck.
l Never clean the mower by pouring water over it: this
may seriously damage the electrical system.
l Frequently remove the wheel screws clean whith pe-
troleum and oil before replacing. Ball bearings must be
greased before remounting.
l Frequently check the blade for damage.
lThe lawn mower must be checked by a SERVICE
DEALER.
Before carrying out any operations on the
cutting tool, stop engine
To carry out this check, you must remove the wheel (17) by
unscrewing the screw (18). Before reinstalling the wheel,
put grease on the pinion and gear.
CAUTION! The blade starts turning as soon as
the mower is started.
CAUTION! The blade starts turning as soon as
the mower is started.
4