Filter
Top Products
English---22
115275126 Rev. 1 9/15/09
TECHNICAL DATA
Attachments Part. no.
Edger attachment with shaft 952 711 607
Cultivator attachment with shaft 952 711 608
Blower attachment with shaft 952 711 609
Brushcutter attachment with shaft 952 711 610
Pruner attachment with shaft 952 711 612
Technical data
128CD 128LD
Engine
Cylinder volume, cu.in./cm
3
1.7/28 1.7/28
Cylinder bore, inch/mm 1.4/35 1.4/35
Stroke, inch/mm 1.130/28.7 1.130/28.7
Idle speed, rpm 2,800--3,200 2,800--3,200
Recommended max. speed, rpm 10,000 11,000
Speed of output shaft, rpm 8,000 8,000
Max. engine output, acc. to ISO 8893, hp/kW 1.1/0.8 1.1/0.8
Catalytic converter muffler Yes Yes
Speed--regulated ignition system Yes Yes
Ignition system
Manufacturer/type of ignition system Walbro/CD Walbro/CD
Spark plug Champion Champion
RCJ--6Y RCJ--6Y
Electrode gap, inch/mm 0.024/0.6 0.024/0.6
Fuel and lubrication system
Manufacturer/type of carburetor Zama Zama
Fuel tank capacity , US pint/liter 0.85/0.4 0.85/0.4
Weight
Weight without fuel, cutting attachment and guard, lbs/kg 10/4.4 11/4.8
Sound levels (see note 1)
Equivalent sound pressure level at the user’s ear ,
measured according to ANSI B175.3--1997, dB(A), min/m ax: 94/97 94/97
Vibration levels
Vibration levels at handles, measured according to ANSI
B175.3--1997, m/s
2
At idle, left/right handles: 3/5 3/5
At max. speed, left/right handles: 9/8 9/8
Note 1: Equivalent noise pressure level is calculated as the time--weighted energy total for
noise pressure levels under various working conditions with the following time distribution:
1/2 idle and 1/2 max. speed.
NOTE! Noise pressure at the user’s ear and vibration on the handles are measured with all the
machine’s approved cutting equipment fitted. The table indicates the highest and lowest values.
Model 128CD (3/8 RH arbor shaft thread)
Approved accessories Type Cutting attachment / guard, part. no.
Trimmer head TNG7 537 41 92-14 / 545 03 11-01
These accessories used in combination with the specified powerheads have been evaluat-
ed to applicable ISO-- and EN safety requirement standards by the Swedish Machinery
Testing Institute:
Model 128LD (M10 LH arbor shaft thread)
Approved accessories Type Cutting attachment / guard, part. no.
Trimmer head T25 537 33 83-06 / 545 03 09-01
Plastic blades Tricut 300 mm 531 00 38--1 1 / 545 03 09-01
These attachments used in combination with the specified powerhead have been evaluated
to ANSI B175.3--2003, “Grass Trimmers and Brushcutters -- Safety Requirements”. These
combinations have been evaluated by Underwriter’s Laboratories Inc. (UL) and are conse-
quently UL listed: