Filter
Top Products
6
. Insert screen into hopper by sliding
it under the screen clips.
Screen
Screen Clips
3
4
. Attach ON/OFF control to the upper
handle using (2) #10 x 3/4” slotted
sheet metal screws. Slide handle grips
onto the handle cross tube. Soapy
water will ease installation. (Do not use
petroleum based products).
5.
Secure On/Off cable to the clamp
bracket using the cable clamp and
#10-24 x 5/8” screw and locknut as
shown but do not tighten. Place On/
Off control in the “ON” position and
set the rate retting dial to the
“WASH” position. Pull cable away
from hopper sliding it in the cable
clamp until the shut off plate stops
against the rate setting dial. Tighten
cable clamp securely. To check
spreader for complete shutoff, pull
the On/Off control lever back to the
“OFF” position. Check to make sure
hole in the hopper is completely
closed. If not, loosen the cable
clamp and slide the cable forward
until the hole in hopper is closed.
Re-tighten bolt and check shutoff
.
Rate Setting
Dial
ON
ON/OFF Cable
Clamp
Bracket
Clamp
Shut Off
Plate
ON/OFF Control
#10 x 3/4”
Sheet Metal Screws
Handle Grip
#10-24 x 5/8”
Screw & Locknut