Filter
Top Products
Start and stop
Start and stop
~WARNING!
● Neverstartthesawenginewithoutthebar,chainandclutch
cover(chainbrake)assembled- or elsetheclutchcancomeloose
andcausepersonalinjuries.
● Alwaysmovethesawawayfromthefuelingareabefore
starting.
● Placethesawoncleargroundandmakesure that the chain is
not contacting anything. Also, make surethat you have a secure
footing.
● Keeppeople and animals well away from the working area.
I
Start
Grio the front handlewith vour left hand and hold the saw down
I
by putting your right foot ii the rear handle.
Pullthe starter handle with your right hand and pull out the starter
cord slowly until the starter pawls engage.Then pull sharply.
Push in the choke control immediatelywhen the engine ignites
and make repeated starting attemps.
When the engine starts, rapidly give full throttle. Then the throttle
latch will disengage.
CAUTION! Do not releasethe starter handlefrom fully pulled out
position as this can cause damageon the saw.
—
Cold engine
CHAIN BRAKE: Disengagethe chain brake by pulling the hand
guard towards he front handle.
IGNITION:
Movethe ignitionswitch to the left.
CHOKE:
Pull out the choke control
IFAST IDLE: Combinedchoke/fast idle is receivedwhen the
I
choke is moved to choke position.
\.\ Iqs+armengine
\“/)/
Usethe sam~ procedureas for starting cold engine but without
choke. Fast idle is recived by pulling out the choke fully first, and
8
pressing it back
again.
stop
The engine is stoppedby switchingoff the ignition.
(Movethe ignition switch to the right.)
3
&
l/{
/g. —-
‘u ,j
—. — -—
r=———
!’, ~
, \ ——
i.—
—,
\s\