Filter
Top Products
34 – English
335XPT
2,7/45
1,7/43
1,22/31
2 800
1,6/9 000
FHP
CD
NGK BPMR 7A
Champion RCJ 7Y
.02"/0,5
Walbro
WT 459 B
0,63/0,3
3-7
0,34/0,16
Automatic
7,5/3,4
14"/34
12"-16"/30-41
11"-15"/28-38
18,3
3/8"
0,050"/1,3
6
TECHNICAL DATA
Engine
Cylinder volume, cu.in/cm
3
Cylinder bore, inch/mm
Stroke, inch/mm
Idle speed, rpm
Power, kW/ rpm
Ignition system
Manufacture
Type of ignition system
Spark plug
Electrode gap, inch/mm
Fuel and lubrication
system
Manufacturer
Carburetor type
Fuel capacity, US pint/litre
Oil pump capacity at
8 500 rpm, ml/min
Oil capacity, US pint/litre
Type of oil pump
Weight
Without bar and chain, Lbs/kg
Chain/bar
Standard bar length,
inches/cm
Recommended bar lengths,
inches/cm
Usable cutting length,
inches/cm
Chain speed at max.
power, m/sec
Pitch, inch
Thickness of drive link,
inch/mm
Number of teeth on drive
sprocket
Recommended bar and chain combinations
Following is a list of recommended cutting equipment for
the Husqvarna Model 335XPT. The combinations of
powerhead, bar and chain have been investigated in
accordance with the kickback requirements of ANSI B
175.1 – 1991. The guide bar nose radius is determined by
either the maximum number of teeth in the nose sprocket or
the corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers
recommendations. There may be other combinations
available, which will also achieve kickback protection.
As we are listing the maximum guide bar nose radius, you
may use a guide bar with smaller nose radius than in our
list. For guide bars of the same length, all sprocket-nose
guide bars of the same pitch and having the same number
of of sprocket teeth may be considered to have equivalent
kickback energy. A hard nose bar having the same length
and nose radius as a sprocket-nose bar may be considered
to have equivalent or less kickback energy than the
sprocket-nose bar.
Low kickback saw chain is a chain which is has met the
kickback performance requirements of ANSI B 175.1 safety
requirements for gasoline-powered chain saws when tested
on the representative sample of chain saws below 3.8 cu.
in. specified in ANSI B 175.1. We recommend that you as
replacement use the listed chains or "Low kickback saw
chains" which are available at your dealer.
FOR U.S. ONLY!
Guide bar Saw chain
Length Pitch Max nose
inch inch radius
12 3/8 7T Husqvarna S36 or Oregon 91VG
14 3/8 7T
16 3/8 7T
1
5
L
Type Inch Inch/mm Inch/mm Angle Angle Angle Inch/mm Inch/cm: dl
91VG 3/8" 0,050"/1,3 5/32" /4,0 85° 30° 0° 0,025"/0,65 12"/30:45 14"/34:52
16"/41:56
S36 3/8" 0,050"/1,3 5/32" /4,0 85° 30° 0° 0,025"/0,65 12"/30:45 14"/34:52
16"/41:56
´*33=¶59¨