Filter
Top Products
GENERAL SAFETY PRECAUTIONS
12 – English
maintain this radius or bevel when you adjust the raker
clearance.
• We recommend that you use our raker gauge to
achieve the correct clearance and bevel on the raker
lip.
Setting the raker clearance
• Before setting the raker clearance the cutting teeth
should be newly sharpened.
We recommend that you adjust the raker clearance
every third time you sharpen the chain. NOTE! This
recommendation assumes that the length of the
cutting teeth is not reduced excessively.
• To adjust the raker clearance you will need a flat file
and a raker gauge.
• Place the gauge over the raker lip.
• Place the file over the part of the lip that protrudes
through the gauge and file off the excess. The
clearance is correct when you no longer feel any
resistance as you draw the file over the gauge.
Tensioning the chain
• The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to
take up the slack.
• Check the chain tension every time you refuel. NOTE!
A new chain has a running-in period during which you
should check the tension more frequently.
• Tension the chain as tightly as possible, but not so
tight that you cannot pull it round freely by hand.
- Undo the bar nut.
- Tension the chain by turning the chain tensioning screw
clockwise using the combination spanner. The chain
should be tensioned until it does not sag from the
underside of the bar.
- Tighten the bar nut using the combination spanner.
Check that the chain can be pulled round easily by hand.
!
WARNING! The risk of kickback is
increased if the raker clearance is too
large!
!
WARNING! A slack chain may jump off
and cause serious or even fatal injury.