Husqvarna 240R Trimmer User Manual


 
22 English
Assembling the handlebars (240R,
245R, 250R)
ASSEMBLY
The handlebars can easily
be turned to fit along the
shaft for easy
transportation and storage.
Loosen the knob. Turn the
handles clockwise so that
the throttle comes against
the engine.
Thereafter fold the
handlebars around the
shaft. Tighten the handle.
Attach the transport guard.
Unscrew the handle from
the handlebar bracket.
Position the handlebars as
shown. Fit the bracket
components and tighten
the handle lightly.
Fit the right hand grip to
the handlebar using the
bolt, washer, sleeve and
nut as shown. Tighten the
bolt.
Put on the harness and
hang the machine in the
suspension hook. Now
finely adjust so that the
machine gives a
comfortable working
position when its attached
to the harness. Tighten the
handle.
Remove the screw at the
rear of the throttle handle.
Slide on the throttle
handle on the right-hand
side of the handlebars, (see
the diagram).
Align the hole in the
throttle handle for the
fixing screw with the hole
on the handlebars.
Refit the screw in the rear
of the throttle handle.
Fit the screw through the
throttle handle and the
handlebars and tighten.
Unscrew the handle from
the handlebar bracket.
Position the handlebars as
shown. Fit the bracket
components and tighten
the handle lightly.
Put on the harness and
hang the machine in the
suspension hook. Now
finely adjust so that the
machine gives a
comfortable working
position when its attached
to the harness. Tighten the
handle.
Assembling the handlebars (245RX,
252RX)
Transport position, handlebars
(240R, 245R/RX, 250R, 252RX)