Filter
Top Products
CONTENTS
Content Page
Table of contents ………………………….. 2
Unpacking .................................................. 2
Transporting ............................................... 2
Sound Data ................................................ 2
Introduction, personal safety ...................... 3
Registration of the product ………………… 4
General safety message ............................ 4
Safety warnings ......................................... 5
Excel series blades ................................... 6
Blade and skid plate installation ................ 6
What is what? ............................................ 7
Operating instructions ............................... 8
Fuel and fuel safety warnings …….…….... 9
Recommended fuels ................................. 9
Recommended oils …….......……….…..… 9
Engine and transmission maintenance ..... 10
Other maintenance ………………….…….. 11
Sawing contraction joints …………....….… 12
Maximizing the Soff-Cut system .......…..... 13
Troubleshooting ......................................... 14
Technical specications ............................. 15
Conformity certicates ............................... 15
Warranty .................................................... 16
Your 2000 saw has been shipped from the factory thoroughly
inspected. Only minimal assembly is required to start using the
saw. Remove the saw from the container using proper lifting
techniques. Discard or recycle the packing material per your
regional laws. In your container will be the 2000 saw, blade
shaft wrench, spark plug wrench, an owner’s manual, an en-
gine owner’s manual, a part list, a warranty card, a joint protec-
tor sample pack and a ramp for unloading the saw. Raise the
saw to its full height by pressing down on the handle bar. Place
the unloading ramp at the edge of the container and roll the
saw out of the container. Lower the saw by pressing down on
the handle bar and squeezing the lever on the handle bar.
NOTE: No diamond cutting blade or skid plate is included
with the saw. Purchase the appropriate Husqvarna Excel
Series 9 or 10 inch blade from your local Husqvarna Con-
struction Product dealer.
CAUTION
Only use the center hook on the
roll cage when lifting the 2000.
The 2000 saw weights approximately 272 pounds (124 ki-
lograms) when ready to use . Use safe lifting practices when
handling the saw. Always remove the diamond blade when
transporting the saw. Always transport the saw with a skid
plate installed. Fold the guide arm back. The saw can be lifted
from the center hook on the roll cage. Always store and trans-
port the saw in a completely lowered position and secured
from moving.
UNPACKING
2
TRANSPORTING
According to Standard ISO 3744:1998 and Directive 2000/14/
EC for environmental sound level and according to Standard
ISO 11201:1995 for sound level at the operator’s position, the
2000 saw emits the following:
Sound power level Lwa 101 dB (A)
Sound pressure level Lpa 87 dB (A)
SOUND DATA
WARNING
Always wear safety approved hearing protection.
Handle bar
Lifting point
Roll cage
Front guide
Rear guide