Filter
Top Products
28 – English
Maintenance
Service position for the cutting unit
The cutting head can be placed in the service position to
provide easy access for cleaning, repairs and servicing. In the
service position the cutting unit is raised and locked in the
vertical position.
Placing in the service position
1 Position the machine on flat ground. Apply the parking
brake. Adjust the cutting unit to the lowest cutting height
and lower the cutting unit.
2 Remove the front hood by removing the pin. (There are
complete instructions on using the service position inside
the front hood).
3 Remove the two support wheels from under the front
hood.
4 Fit the support wheels on either side of the rear of the
cutting unit.
5 Disengage the spring for the drive belt tensioning wheel.
Rider 175
Rider 175 AWD
6 Place a foot on the front edge of the cutting unit near the
wheel and raise the front edge of the unit to make it easier
to remove the lift strut.
7 Engage the strut in the holder.
!
WARNING! Wear protective glasses when
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.
!
WARNING! Observe caution to avoid
trapping your hand.