Filter
Top Products
26 – English
Maintenance
Make sure that the tongue (3) on the cutting unit engages
correctly.
3 Insert the bolt and secure it with a locking pin.
4 Press down the frame and insert the pin. Fit the drive belt
around the drive wheels of the cutting unit.
5 Hook up the height adjustment strut.
6 Move the support wheels to their parking position.
7 Fit the front cover.
8 Secure the collet spring.
Rider 175
Rider 175 AWD
Removing the cutting unit
1 Carry out points 1-9 to put the cutting unit in the service
position, see Service position for the cutting unit.
2 Remove the bolt (3) and lift off the cutting unit.
Checking and adjustment of the
cutting unit’s ground pressure
To achieve the best cutting results the cutting unit should
follow the underlying surface without pressing too hard
against it.
Pressure is adjusted using a screw and spring on each side
of the Rider.
1 Check the air pressure in the tyres 60 kPa/0.6 kp/cm
2
/8.5
PSI.
2 Place the machine on a flat surface.
3 Put the lifting lever in the mowing position.
!
WARNING! Observe caution to avoid
trapping your hand.
!
WARNING! Wear protective glasses when
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.
2
3
1