Husqvarna 16C Lawn Mower User Manual


 
En
g
lish
5
Ser
vice journal
Pre-deliver
y service
1
1a. Dry-charged battery (506788801)
Top up battery with acid and charge for four hours.
1b.
Wet-charged battery (510138501)
Charge the battery for 4 hours at max. 3 amp.
2 Fit steering wheel, seat and any optional equipment.
3 Check and adjust tyre pressure (60 Kpa, 0.6 bar, 9 PSI).
4 Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4 mm / 1/8” higher than front edge.
Adjust cutting unit height setting so that cutting height limit is 5 mm / 3/16” above the frame of the unit at the lowest cutting
height.
5 Check that the right amount of oil is in the engine.
6 Check that the right amount of oil is in the transmission. (Not Rider 11).
7 Connect battery.
8 Fill with fuel and start engine.
9 Check that machine does not move in neutral.
10 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
Safety switch for the hydrostat pedals/neutral position.
Check engine speed. See the Technical data section.
11 Check the synchronisation between the front and rear wheels. (Rider 16 AWD) See the workshop manual.
12 Tell customer about:
Needs and benefits of following the service schedule.
Servicing and the influence of this journal on the second-hand value of the machine.
Range of applications for BioClip.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems. Certified:
Date
, mileage, stamp, signature
After the fi
rst 8 hours
1
Change engine oil
2 Change the oil in the gearbox. (Only AWD-machines)