Filter
Top Products
English – 43
8009-585
6008-240H
6008-232
6021-030
LUBRICATION
Check the transmission’s oil level
Rider 13 C, Rider 13 AWD and Rider 15 C
1. Lift off the transmission cover. Release the two
screws (one of each side) and lift off the trans-
mission cover.
2. Rider 13 C, Rider 15 C
Check that there is oil in the transmission oil
tank. Top up if necessary with engine oil SAE
10W/30 (class SF–CC).
Rider 13 AWD
Check that there is oil in the transmission oil
tank. Top up if necessary with engine oil SAE
10W/40 (class SF–CC).
The oil should be changed by an authorised service
workshop, and is described in the Workshop
Manual.
The filter is replaced at the same time as changing
the oil.
Work on the system entails particular demands on
cleanliness and the system must be vented before
the machine is used.
Lubrication of belt tensioner
The belt tensioner must be lubricated regularly with
high-quality molybdenum sulphide grease*.
Inject grease into the nipple on the right side below
the engine bottom pulley until grease is forced out.
With daily use lubrication should be conducted
twice a week.