Husqvarna 13 AWD Lawn Mower User Manual


 
English – 23
At least
once
a year
50 100
Page
Maintenance interval
in hours
MAINTENANCE
25
Maintenance
Daily
mainte-
nance
before start
= Described in these instructions.
= Not described in these instructions.
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.
1)
First change after 5 hours. Replace after every 25 hours with heavy loads or high temperatures.
2)
During dusty conditions cleaning
and replacement should be more frequent.
3)
For daily use of the machine lubrication should be conducted twice a week.
4)
Conducted by
authorised service workshop.
5)
Rider 13 AWD only. Replace first after 8 hours.
Cleaning 24
Check the engine’s oil level 42
Check the engine’s cooling air inlet 35
Check the fuel pump’s air filter 32
Check the steering wires 27
Check the brakes 28
Check the battery 32
Check the safety system 33
Check screws and nuts
Check for fuel and oil leakage
Clean around the silencer
Inspecting the silencer 26
Change the engine oil
1)
42
1)
1)
Clean the air filter’s pre-filter
2)
31
Check the cutting unit 36
Check the tyre pressures (60 kPa / 8.5 PSI) 35
Lubricating the belt adjuster
3)
43
Lubricate joints and shafts
3)
44
Adjust the brakes Rider 11 and Rider 11 C 28
Check the V-belts
Check the transmission’s cooling flanges
Rider 13 C, Rider 13 AWD and Rider 15 C
Check the transmission’s oil level
Rider 13 C, Rider 13 AWD and Rider 15 C 43
Adjust the brakes Rider 13 C and Rider 15 C 28
Adjust the brakes Rider 13 AWD 29
Check and adjust the throttle wire 30
Clean the cooling flanges on the engine and
transmission
2,4)
Replace the air filter’s pre-filter and paper filter
2)
31
Replace the fuel filter 30
Replace the plug 32
Check the valve clearance
4)
Check the need of an oil change
4,5)
in
the gearbox/hydraulic system ❍❍
• The engine is switched off.
• The ignition key is removed.
• The ignition cable is removed from the plug.
• The parking brake is applied.
• The cutting unit is disengaged.
200