Husqvarna 1340PW Pressure Washer User Manual


 
8 — English
2. Connect clear plastic hose to brass barb on pump
(See Figure 2).
3. Secure garden hose (not included) to the inlet
connection on pump (See Figures 3 and 4).
PRE-OPERATION
UNPACKING
Remove the equipment and all parts from the
carton. The carton should contain the following.
One pressure washer (pump, engine, cart base).
One cart handle assembly.
One spray gun.
One lance.
Two spray tips for Model 5525PW
Five spray tips for Models 1340PW, 6027PW and
9032PW
One high pressure hose.
One pack of nuts, bolts, and manuals.
One bottle of engine oil.
If any parts are missing, Please contact your
Husqvarna dealer.
After unpacking the product, inspect it carefully for
any damage that may have occurred during transit.
Make sure to tighten fittings and bolts before using
the pressure washer.
DO NOT operate the unit if it’s
damaged during shipping,
handling, or use. Damage could result in bursting
and cause injury or property damage.
ASSEMBLY
Use 1/2” (13 mm) wrench to assemble pressure
washer. On model 5525PW use two adjustable or
7/16” wrenches.
1. Slide the handle assembly over the lower legs of
the cart base. Use the standard nut and bolt to
secure the legs. See Figure 1.
!
WARNING
Figure 1 - Assemble Handle
Figure 2 - Connect hose to brass barb
Figure 3 - Secure garden hose
Garden Hose
High Pressure
Hose
Figure 4 - Connect high pressure hose to pump
Garden Hose
High Pressure
Hose