Filter
Top Products
English — 15
OPERATION
3. Disconnect the water supply and high pressure hose
from the pump.
4. Allow the engine to cool.
5. Disconnect the spark plug wire and remove the
spark plug.
6. Pour 1/2 oz. of engine oil into the spark plug hole.
NEVER pull the
starter rope on the
engine when the spark plug is removed
unless the spark plug hole is covered.
Fuel vapor from the hole can ignite by a
spark.
7. Place a rag over the spark plug hole and slowly pull
the starter rope several times to distribute the oil.
8. Disconnect the high pressure hose from the pump.
9. Insert a 12” to 14” piece of garden hose into the
pump inlet.
10. Place a funnel in the other end of the garden hose.
Read the manufacturer’s
instructions for safe handling
and disposal of RV antifreeze.
11. Pour approximately 6 oz. of RV antifreeze into
the funnel.
12. Pull the starter rope several times until the RV
antifreeze comes out of the pump outlet.
13. Disconnect the high pressure hose from the gun
and drain the hose. Hold the gun and lance in a
vertical position and squeeze the trigger to
drain the water.
NOTICE
!
WARNING
Never store the pressure washer
with gasoline in the tank inside
a building where fumes may reach an open flame or
spark. Allow the engine to cool before storing in
any enclosure.
NOTE: To winterize unit, please follow the same
intructions for Storage.
TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE
WASHER
• NEVER operate the unit without water.
• Your pressure washer is not meant to pump hot
water. NEVER connect your pressure washer to a
hot water supply as it will significantly reduce
the life of the pump.
• Running the unit for more than two minutes
without spraying water causes heat to build up
in the pump. Running the unit without spraying
water can damage pump components.
• Release the trigger prior to switching the lance
between high and low pressure. Failure to do so
may reduce the life of the o-rings in the lance.
!
CAUTION