Husqvarna 115 149727 R01 Blower User Manual


  Open as PDF
of 24
 
8
Removethedischargechutefromthedeck.(Deck1.
congurationwillvarybysizeandmodel)
Lowerdecktothelowestcuttingposition.2.
To prevent interference with the new belt shield, 3.
reverse the bolt/nut assembly on the rear of the
deckheightadjustmentplate.
Removetherighthand(dischargeside)beltcover4.
fromthedeck.
ASSEMBLY
1
INSTALLING DRIVE PULLEY
2
MOUNTING BLOWER ASSEMBLY
Outer Pulley Cover
Pin
Hairpin Cotter
DeckHeight
Adjustment
Belt Cover
1. Installthefrontmountbrackettothedeckwiththe
pinandhairpincottersuppliedwiththekit.
Discharge Chute
Reverse rear
bolt/nut
assembly
5. Removetheboltsecuringtherighthanddeck
pulley to the spindle.
6. Replace right blade shaft with new, longer shaft.
Theexistingdrivepulleyandkeywilltonthenew
shaft. Install blower drive pulley with the raised
portion of pulley hub down. Slide spacer inside
newpulley.Addkeytonewpulley.
7. Remove two rear bolts from spindle and place belt
shield standoff where the two bolts were removed.
Replace bolts and tighten.
Drive Pulley
Key
Replacement Shaft
Belt Shield
Standoff
Spindle
New Heavy Washer
New Bolt
Spacer
8. Useheavywasherandboltsuppliedinkittoattach
pulley to spindle. Torque to 55-75 ft/lbs.
9. Reinstallthedeckbelt.
 previous next