Husqvarna 115 149727 R01 Blower User Manual


  Open as PDF
of 24
 
10
ASSEMBLY
7
INSTALLING BAGGER MOUNT
6
TRIMMING MIDDLE CHUTE
1. Usingthehacksaw,trimalongthedashedline.
2. Locatethemiddlechute,atwasher,hoodlatch,
weldnut,lockwasherandmachinescrewfromkit.
3. Install in the appropriate hole at the upper end of
themiddlechute,accordingtodecksize.
Trim Line
Hood Latch
Weld Nut
Machine Screw
LockWasher
Latch Location
Flat Washer
7
INSTALLING MIDDLE CHUTE
1. Place middle chute over the top end of the blower
assembly.
2. Latch middle chute to blower assembly.
Middle Chute
Blower Assembly
Usinghardwareprovidedinkit,attachsupport1.
mount to unit.
Attachhangerbrackettosupportmount.Donot2.
fully tighten nuts at this time.
HangerBracket
Secure rear end of support straps to outside of 3.
hanger assembly. Set reinforcement plates to the
outsideofthetankbracketsandfastenfrontend
ofsupportstraptotankbracketandreinforcment
plate with round head bolt. Secure front end
ofreinforcementplatetotankbracketwithhex
bolt. Fully secure all mounting hardware. See
illustration.
NOTE: Rear guard hole may need to be drilled out
to
5
/16"ifkithardwareistoolarge.
Support Mount
Support Straps
Reinforcement Plate
Hex Bolt Placement
Round Head
Bolt Placement
 previous next