Filter
Top Products
Start-Up and Operation
9312 4-3
Clean the strainer immediately after the pump has been installed and tested, and again after a few
hundred gallons have been delivered. Thereafter, once every six months, or as required. The
procedure for cleaning the stainer can be found in the
Maintenance and Troubleshooting
section.
DAILY OPERATION
1. To begin fueling, remove the nozzle from the boot and turn on the pump handle.
2. If your model has an automatic reset, the register resets to zeros. If your model has a reset
button, push it to zero the register.
3. Dispense fuel.
4. Turn the pump handle off. The amount delivered is displayed on the register.