Filter
Top Products
16
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
WARNING:
Before inspecting, cleaning or servicing the machine, shut
off engine, wait for all moving parts to stop, and discon-
nect spark plug wire and move it away from spark plug.
Failure to follow these instructions can result in serious
personal injury or property damage.
NOTE: The Briggs and Stratton Q45™ engine has a separate
warranty found in the engine manual (included with this
product).
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an
authorized service center.
Before running the engine, perform the following pre-
operation steps:
Check that all bolts, nuts, etc., are securely tightened.
�Make sure the air filter is clean.
�Check both the engine oil level and the fuel tank level;
refill as needed.
�Inspect the work area for hazards.
�If there is excessive noise or vibration, stop the unit
immediately.
CLEANING THE AIR FILTER
See Figure 16.
A dirty air filter will cause starting difficulty, loss of
performance, and shorten the life span of the engine. Check
the air filter monthly. For best performance, replace the air
filter at least once a year.
Remove the shroud screws holding the shroud in place
as shown in figure 16.
Remove the air filter cover.
Lift the edge of the air filter carefully and pull it out.
Wash the air filter with warm, soapy water.
Rinse and squeeze to dry.
Put small amount of SAE 30 motor oil on the filter sponge.
Squeeze out the excess oil then reinstall the air filter.
NOTE: Make sure the filter is seated properly inside the
cover. Installing the filter incorrectly will allow dirt to enter
the engine, causing rapid engine wear.
Reinstall the air filter cover and tighten securely using the
air filter screw.
Retighten the shroud screws.
Fig. 16
AIR FILTER
AIR FILTER
COVER
AIR FILTER
SCREW
SHROUD
SHROUD
SCREW