Filter
Top Products
13
42221-01 • 06/04/12 • Hunter Fan Company
Step 7-9
Step 7-9
Steps 7-12 – 7-14
7 • Completing Your Installation With a Bowl Light Fixture (continued)
Connector
Step 7-10
Step 7-11
7-9. Install E-26 60 watt light bulb. When necessary, replace with bulb of the
same wattage.
Note: e reversing switch is located on the switch housing. It can only
be accessed when globe is removed.
Attaching the pull chain pendants:
7-10. Feed the pull chains from the fan switch and the light switch down
through the holes in the upper switch housing. (You may nd a
connector on the end of the pull chain. If so, remove and dispose of it. )
7-11. Attach the pull chain pendants to the light and fan pull chains using
the connector.
Installing the globe:
7-12. Position the indentations in the outer rim of the globe so that they line
up with the tabs on the inside surface of the light xture rim.
7-13. Carefully lift the globe up inside the light xture as far as it
will go.
7-14. Rotate the shade in a clockwise direction until it is held tightly in place
by the three tabs.
Globe
Bulb
Reversing
Switch
Pull Chain
Pendant
Fan
Light