Hunter Fan 23348 Outdoor Ceiling Fan User Manual


  Open as PDF
of 12
 
7
42664-01•06/09/08•HunterFanCompany
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
4-1.Unbundlethewiresfromthefanandremovethepapercaution
tag. Do not discard the tag until your installation is complete.
For Standard or Angled mounting:
4-2.Toassemblefantohangdownfromaatorangledceiling,
insert the downrod through the canopy, adapter cover grommet,
adapter cover, and canopy trim ring. (e adapter cover and
adapter cover grommet may already be attached to make one
piece.) Feed the wires from the fan through the downrod.
4-3. Loosen the square-head setscrew on the adapter to install the
pipe and ball assembly. Note: When the pipe and ball assembly
isfullyinstalled,2-3threadsonthepipewillstillbevisible;thisis
normal. Securely retighten the setscrew with a wrench or pliers.
Skip to Step 5-1.
CAUTION: e adapter has a special coating on the threads. Do
notremovethiscoating;thecoatingpreventsthedownrodfrom
unscrewing.Onceassembled,donotremovethedownrod.
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the low
profile washer. e adapter cover and adapter cover grommet are not
used for low profile mounting.
4-4. Removethesetscrewfromtheadapter.
4-5. Place the low profile washer (lip up) into the canopy. Be sure the
green ground wire is pointing up toward the ceiling.
4-6.Aligntheholesinthewasherwiththeholesintheadapter.
Assemblesecurelywiththreelowprolescrews.
Steps 4-5 – 4-6
Low Profile Screw
Low Profile Washer
Steps 4-2 – 4-3
Downrod
Canopy
Canopy
TrimRing
Adapter
Cover
Adapter
Cover
Grommet
Setscrew
4 • Assembling and Hanging the Fan
 previous next