Filter
Top Products
English -51
LUBRICATION
Lubricating With The Schedule
Caster wheels
Lubricate with a grease gun. One zerk for each
bearing, two strokes. Use only good quality grease.
See General in Lubrication.
Engine Oil
Changing the Engine Oil
The engine oil should be changed for the rst time
after 5-8 hours of operation. Thereafter, it shall be
changed every 50 hours.
1. Place the machine on a at surface.
2. Remove the yellow cap and t a hose to the drain
valve.
3. Place a container under the engine where the hose
from the oil drain valve exits.
4. Remove the dipstick and open the drain valve by
turning and pulling out the black sleeve.
5. Allow the oil to run out into the container.
6. Then close the oil drain valve.
7. Remove hose and install the yellow cap. The cap
must be installed to stop ow if the valve is opened
by mistake.
8. Replace the oil lter if necessary.
9. Fill with new engine oil in accordance with
Checking the Oil Level.
10. Start the engine. Run it for a few seconds. Stop
and recheck the oil level.
8011-717
Caster wheel zerk
WARNING!
Engine oil can be very hot if it is
drained directly after stopping
the engine. Allow the engine to
cool for a 2-3 minutes before
maintenance.
8011-409
Oil drain valve
IMPORTANT INFORMATION
Used engine oil is a health hazard and
must not be disposed of on the ground or
in nature; it should always be disposed
of at a workshop or appropriate disposal
location.
Avoid skin contact; wash with soap and water in
case of spills.