Filter
Top Products
1817
Remote Sensor
Temperature
Proposed operating range
with alkaline batteries : -20°C to + 70°C /
-4°F to 158°F
Proposed operating range
with lithium batteries : - 38°F to 158°F
( -38.8 C° to 70°C)
Temperature resolution : 0.1°C/ 0.2°F
Humidity
Proposed operating range : 25% to 90%
Resolution : 1%
RF Transmission Frequency : 433 MHz
Maximum number of Remote sensors : 3
RF Transmission Range : Maximum 100 feet
Temperature sampling cycle : approximately
45 seconds
Calendar and Clock
12 hour display in hh : mm format
Date Format: Month – Day format
Day of week: User- selectable in 5 languages
(English, Spanish, French, German, Italian)
Dual 4-minute crescendo alarm with snooze
Pre-alarm for ice alert with programmable time intervals
Blue Backlight
Wall Mount or Table Stand
Power
Main unit : 2 AA batteries
– alkaline are suggested (not included)
Remote Sensor : 2 AA batteries
– alkaline are suggested (not included)
Dimensions
Main unit : 3.68”(L) x 7.31”(H) x 1.31”(D)
Remote sensor : 2.37”(L) x 4”(H) x 1”(D)
FCC STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modification to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment had been tested and found to comply
with the limits for a Class B Digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio / TV
technician for help.