Filter
Top Products
1817
2019
BACKLIGHT
The backlight feature is enabled only after the time is set.
To activate the backlight press the SNOOZE/LIGHT button
once, and both – clock and weather station displays - will
light up for five seconds.
PRECAUTIONS
• This product is engineered to give you years of satisfactory
service if handled carefully. Here are a few precautions:
• Do not immerse the units in water.
• Do not clean the units with abrasive or corrosive
materials. They may scratch the plastic parts and corrode
the electronic circuits.
• Do not subject the product to excessive force, shock, dust,
temperature, or humidity, which may result in malfunctions,
shorter lifespan, damaged batteries, and damaged parts.
• Do not tamper with the units internal components. Doing
so will invalidate the warranty and may cause damage.
These units contain no user-serviceable parts.
• Use only fresh batteries. Do not mix new and old
batteries.
• Read the user's manual thoroughly before operating the
units.
TROUBLESHOOTING
Check here before contacting customer service.
SPECIFICATIONS
Main Unit
Indoor Temperature
Proposed operating range : -5.0°C to +50.0°C/
23.0°F to 122.0°F
Temperature resolution : 0.1°C/0.2°F
Indoor Humidity
Proposed operating range : 25%RH to 90%RH
Humidity resolution : 1%
Comfort level indicators – COMFORT, WET and DRY
User-selectable (°F or °C) temperature display
Weather Forecast in five large
graphic icons :
Sunny, Partly Cloudy,
Cloudy, Rainy and Snowy
Remote channels auto-scan feature
Maximum number of remote sensors : 3 (one included)
Readings update interval : every 45 seconds
EL backlight for the weather station ; Bulb backlight for
analog clock
Low battery indicators – for each remote channel and main unit
Clock
Precise Quartz Time
Crescendo 2 minutes alarm with 4 minutes snooze
Remote Sensor
Remote Temperature
Proposed operating range
with alkaline batteries
: -20.0°C to + 70.0°C/
-4.0°F to + 158°F
Proposed operating range
with lithium batteries :
-38.8°C to + 70.0°C/
-38.0°F to +158°F
Temperature resolution : 0.1°C/0.2°F
RF Transmission Frequency : 433 MHz
RF range: Maximum 200 feet (60 meters)
Temperature & humidity transmission cycle: approximately
45 seconds
Low battery indicator
Wall-mount of Table stand
Power
Main unit : 2 AA size (UM-3) 1.5V
batteries (not included)
Remote Sensor : 2 AA size (UM-3) 1.5V
batteries (not included)
Dimensions
Main unit : 3.32(L) x 6.97(H) x
1.49(D) inches
Remote sensor : 2.37(L) x 4(H) x
1(D) inch
FCC STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modification to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment had been tested and found to comply
with the limits for a Class B Digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment, installed and used
in accordance with the instructions, may cause harmful
interference to radio communications.
There is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to improve or correct turning the interference by
one or more of the following measures:
•Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver.
•Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
•Consult the dealer or an experienced radio / TV technician
for help.
DECLARATION OF CONFORMITY
We
Manufacturer: Hideki Electronics Ltd.
Address: Unit 2304-06, 23/F Riley House, 88 Lei Muk Road,
Kwai Chung, New Territories, Hong Kong
declare that the product
Product No.: TC682EL
Product Name: Honeywell Wireless Digital Weather Station
with Analog Clock is in conformity with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including
interference that may cause undesired operation.
The information above is not to be used as a contact for
support or sales.
Issue Symptom Solution
Temperature or
Humidity
Remote sensor
Displays "LL" or
"HH"
Cannot locate remote
sensor
Cannot change the
channel
Cannot change the ºC
to ºF and back
Data does not match
data on the main unit
Temperature or
humidity out of range
Check batteries
Check location
Press "RESET" after
setting the channel
Press "RESET" after
setting ºC/ºF
Initiate manual sensor
search