Filter
Top Products
Page 11
ADDING OIL
See Figures 9 and 10.
Use HOMELITE Bar and Chain Oil. It is designed for
chains and chain oilers, and is formulated to perform over
a wide temperature range with no dilution required. Chain
saw should use approximately one tank of oil per tank of
fuel.
Note: Do not use dirty, used or otherwise contaminated
oils. Damage may occur to the oil pump, bar, or chain.
1. Carefully pour the bar and chain oil into the tank.
2. Fill the oil tank every time you fuel the engine.
OPERATION
STOP
Fig. 9
Fig. 10
Fig. 8
OPERATING THE CHAIN BRAKE
See Figures 10, 11 and 12.
Refer to “Safety” earlier in this manual for additional
information.
Check the operating condition of the chain brake prior to
each use.
1. Using the back of your left hand, engage the chain
brake by pushing the chain brake lever/hand guard
toward the bar while the chain is rotating rapidly.
2. Reset the chain brake back into the RUN position by
grasping the top of the chain brake lever/hand guard
and pull toward the front handle until you hear a click.
WARNING:
If the chain brake does not stop the chain
immediately, take the saw to a Homelite Service
Center for repair prior to use.
BRAKE POSITION
Fig. 11
Fig. 12
RUN POSITION